Lathe Machine SOP (Standard Operating Procedure)

Lathe Machine SOP (Standard Operating Procedure)All stock must be legitimately secured in the machine toss or mounted preceding the machining procedure occurring. Utilize the right measured clip or tight clamp for the stock being machined.

Turn the hurl or faceplate by hand to guarantee there is no coupling or peril of the work striking any piece of the machine.

Check to guarantee the cutting instrument won’t run into the toss or machine canine. In the event that conceivable, sustain far from the hurl or puppies.

Before beginning the machine, guarantee the axle work has the container focus imbedded; tail, stock and device rests are safely clipped; and there is fitting leeway for the turning stock.

Preceding beginning the machine, guarantee that little breadth stock does not extend to a long way from the throw without backing from the tail stock focus.

At the point when utilizing wood, don’t mount a part work piece or one containing bunches.

At the point when roughing stock, don’t drive the instrument in the work piece or take too enormous a cut.

The administrator should dependably be mindful of the course and rate of the carriage or cross-bolster preceding captivating the programmed food.

Never leave the key in the throw. Don’t let go of the key until it is free of the toss and secured in its legitimate holding spot.

Select turning speed deliberately. Vast distance across stock must be turned at a low speed. Continuously utilize the least speed to harsh out the stock preceding last machining.

The right speed and food for the particular material and cutting instrument must be utilized. Stop the machine before making alterations or estimations.

Read more about   Lathe Machine Operations "Taper Turning"

Don’t expel metal or wood chips from the table or stock by hand. Utilize a brush or other device to appropriately expel chips or shavings from the table or stock.

Never endeavor to run the toss on or off the axle head by captivating the force.

Don’t stop the revolution of the toss by switching the ability to the machine unless tapping openings.

Don’t leave devices, bits or abundance bits of stock on the machine bunk.

All belts and pulleys must be protected. On the off chance that frayed belts or pulleys are watched, the machine must be taken out of administration and the belts or pulleys supplanted.

Stop the machine instantly if odd commotion or intemperate vibration happens.

Just appropriately honed bores and cutting devices in great condition ought to be utilized. Dull boring tools and chipped or broken cutting devices must be expelled from administration.

Detach the machine from force source and take after OSEH Guideline Ihs011, Lock-out/Tag-out – Control of Hazardous Energy Sources if making repairs or overhauling.

At the point when an administrator has completed the process of dealing with the machine, and before leaving the machine for any reason, the force must be stopped and the machine must arrive at a complete stop.

At the point when an administrator watches a perilous condition with the machine or stock being met expectations, the administrator must report it promptly to the assigned MSSA and the machine should be taken out of administration until the issue has been remedied.

Leave a Reply